Chicken Tractor plans
For 6 standard hens kept in: an 8 × 8 ft coop, about 6 sheets of plywood and 22 2×4s.
It suits hens kept inside all day if you can move the tractor every day or two. The 4 × 8 ft plan is for 3 hens; for 12, the 10 × 12 ft tractor is too heavy to move by hand, so use a coop with a run.
Chicken Tractor plan for 6 standard hens kept in
Chicken Houses (chickenhouses.app). A planning estimate, not an engineering plan.
Side view and frame list for 6 hens
- The hens live in the tractor all day, so it is sized by the kept-in rule (8-10 sq ft per hen, Oregon State). Move it every day or two.
- Open ground floor: the walls are hardware cloth on the front and left, plywood on the back and right.
Frame list
Studs and rafters at 24″ on centre, floor joists at 16″ (common practice). Lengths are cut lengths.
| Part | Size | Length | Count |
|---|---|---|---|
| Floor rim joist | 2×6 | 8′ | 2 |
| Floor joist | 2×6 | 7′9″ | 7 |
| Top and bottom plate | 2×4 | 8′ | 2 |
| Top and bottom plate | 2×4 | 8′ | 2 |
| Top and bottom plate | 2×4 | 8′ | 2 |
| Top and bottom plate | 2×4 | 8′ | 2 |
| Front wall stud | 2×4 | 3′9″ | 5 |
| Back wall stud | 2×4 | 3′1″ | 5 |
| Side wall stud | 2×4 | 3′5″ | 10 |
| Door framing stud | 2×4 | 3′9″ | 4 |
| Door header | 2×4 | 2′9″ | 2 |
| Rafter | 2×6 | 9′ | 5 |
| Roost bar | 2×2 | 8′ | 1 |
| Pull handle | 2×4 | 4′ | 2 |
Materials
Counts only, no prices. Lumber is bought as 8 ft boards, sheets carry 10% waste.
| Item | Count | Note |
|---|---|---|
| Lumber 2×6, 8 ft board | 15 boards | Cuts packed on 8 ft boards; long members spliced. |
| Lumber 2×4, 8 ft board | 22 boards | Cuts packed on 8 ft boards; long members spliced. |
| Lumber 2×2, 8 ft board | 1 board | Roost bars: round the top edges (Utah State: 2 × 2 in with rounded tops). |
| Plywood or OSB, 4 × 8 ft sheet | 6 sheets | Floor, walls, roof deck and nest boxes, with 10% waste. |
| Roofing panel, 26 in cover × 8 ft | 10 panels | 10% waste across the width. |
| Hardware cloth ½ in, 3 ft × 50 ft roll | 1 roll | About 27 ft of the 3 ft width for vents, run or open walls, with 10% waste. |
| Hinge, exterior | 8 hinges | Pop door, access door, nest lids. |
| Latch, two-step predator-proof | 4 latches | Raccoons open a simple hook. |
| Exterior wood screws, 1 lb box (about 150 of 2½ in) | 4 boxes | Six per framing member and forty per sheet. |
| Roofing screws with washers, box of 100 | 2 boxes | Sixteen per panel. |
| Wheel, 8 in, with axle bolt | 2 wheels | Fit at one end so the tractor tips onto them. |
Not an engineering plan: an estimate
Part counts and lengths are planning estimates from the same rules as the planner. Check them against your local building rules, your lumber and your site before you cut.
- Check local building and zoning rules before you build.
- Check the wind and snow loads where you live.
- Check the predator side: predator proofing.
What the coop must have
The spec for 6 hens: the least each source allows, the recommended figure, and what this chicken tractor has.
| Part | Minimum | Recommended | This plan | Rule and source |
|---|---|---|---|---|
| Coop floor | 48 sq ft | 60 sq ft | 64 sq ft (8 × 8 ft) | 8 sq ft per hen minimum, 10 recommended when the hens never go outOregon State University ExtensionSources range from 1.5 to 10 sq ft per hen; 1.5-3 if the hens go out to a run (Penn State, Oregon State). |
| Roost | 36 in | 60 in | 96 in, one bar 24 in high, 14 in from the back wall | 6-10 in per hen, 24 in high, at least 12 in from wallsPenn State Extension, UC Davis School of Veterinary Medicine, Oregon State University Extension, University of Kentucky Cooperative Extension |
| Nest boxes | 2 | 2 | 2 boxes 12 × 12 × 12 in, 24 in high | 1 box per 4-5 hens, 12 × 12 × 12 in, floor at least 18 in and not lower than the roostOregon State University Extension, Utah State University Extension, Penn State ExtensionPenn State asks for more: two nests for the first four hens, then one per four more (3 for 6 hens). |
| Feeder | 18 in | 18 in | round feeder 12 in across = 37.7 in of edge | 3 in of feeder edge per henPenn State Extension |
| Water | 1 nipple | 1 nipple | bucket with 2 nipples | 1 nipple per 6-8 birdsPenn State Extension |
| Vent | 6.4 sq ft | 6.4 sq ft | 6.4 sq ft in strips on the front and back walls | about 1 sq ft per 10 sq ft of floor; never directly over the roostCommon practice, Penn State ExtensionNo extension service gives a vent area; the figure is common practice. Penn State: vents must not open over the perches. |
Next
See this flock in the planner: move a nest box, check the roost, print the sheet.

Frame and materials
The frame has 14 members. The estimate calls for 15 2×6 boards and 22 2×4 boards, plus one 2×2 board. Six plywood or OSB sheets form the solid walls and covered areas; hardware cloth covers the front and left sides, while plywood or OSB closes the back and right. Roofing panels, hinges, two-step latches, screws and two wheels complete the main materials.
Before you build
Check local rules for coop placement and construction before choosing a spot. Secure the open sides and openings against local predators, and make sure doors can be fastened with the two-step latches. Provide ventilation without leaving large gaps predators can enter. Consider how wind could catch the roof and exposed sides, and whether snow could collect on the roof or block ventilation.
Choose a flock size
Use the 4 × 8 ft plan for 3 hens and the 8 × 8 ft plan for 6. The 8 × 8 ft tractor is already at the stated limit for hand moving; a 10 × 12 ft tractor for 12 hens would be too heavy to move by hand. Keep a tractor at or below 6 hens, or choose a coop with a run for a larger flock.
Questions
How often should I move this tractor?
Move it every day or two. The hens live in the tractor all day, so the open ground floor gives them access to the ground within their enclosure. Choose a route and location that let you move it regularly.
Why are some walls solid and others open?
The front and left sides use hardware cloth, while plywood or OSB closes the back and right. This gives the ground floor an open side while keeping solid wall sections in the structure. Check that the cloth and openings are secure against predators.
Can I use this tractor for 12 hens?
No. The 10 × 12 ft plan for 12 hens exceeds the stated hand-moving limit: a tractor above 64 sq ft is too heavy to move by hand. Use a coop with a run for that flock size.